CDM860 Wheel Loader
Technical Paramters
Overall Data |
|
||||
Bucket Capacity (m3) |
3.5 |
||||
Rated Payload(kg) |
6000 |
||||
Operating Weight(kg) |
20400±300 |
||||
Traction Force(kN) |
172±3 |
||||
Breakout Force(kN) |
200±3 |
||||
Travel speeds (km/h): |
|||||
|
I |
II |
III |
IV |
|
Forward |
6.4 |
11.1 |
17.4 |
29.2 |
|
Reverse |
7.2 |
12.9 |
20.8 |
31.1 |
|
Engine |
WEICHAI WD10G240E21 |
||||
Rated Power(kW/rpm) |
175/2200 |
||||
Peak Torque(Nm/rpm) |
920/1400-1600 |
||||
Starting Voltage(V) |
24 |
||||
Drive Train |
|
||||
Torque Converter |
Single-stage, Single-turbine, 3-element |
||||
Torque Ratio |
2.56 |
||||
Transmission |
Planetary Powershift Transmission |
||||
Gear |
4F/4R |
||||
Pressure of Transmission(MPa) |
1.7~1.9 |
||||
Main Reducer |
Spiral Bevel, 1-stage Reduction |
||||
Final Reducer |
Planetary Reduction |
||||
Tire |
23.5-25 L-3 20PR |
||||
Brake System |
|
||||
Service Brake |
Duo-Circuit Air Drive Brake |
||||
Setting Pressure (MPa) |
0.78 |
||||
Parking Brake |
Air Drive Brake |
||||
Emergency Brake |
Air Drive Brake |
Steering System |
|
|||
Type Hydraulic Load Sensor System |
||||
Cylinders-bore×Stroke(mm) |
2-100×324 |
|||
Steering Pump |
Gear Pump |
|||
System Pressure(MPa) |
16 |
|||
Flowrate(L/min/RPM) |
176/2200 |
|||
Steering Angle |
±35° |
|||
Hydraulic System |
|
|||
Lift Cylinders-bore×Stroke(mm) |
2-180×864 |
|||
Tilt Cylinder-bore×Stroke(mm) |
1-200×626 |
|||
Model of Implement Pump |
Gear Pump |
|||
Flowrate(L/min/RPM) |
275/2200 |
|||
System Pressure(MPa) |
16 |
|||
Pilot Control System Pressure(MPa) |
2.5 |
|||
Hydraulic cycle time, rated load in bucket(in second): |
||||
Raise(Loaded) |
Dump |
Lower(Empty) |
Total |
|
6.3 |
1.2 |
4.3 |
11.8 |
|
Electrical System |
||||
System Voltage(V) |
24 |
|||
Battery (2 in series)(Ah) |
120 |
|||
Lamp Voltage(V) |
24 |
|||
Service Refill Capacity |
|
|||
Fuel Tank(L) |
285 |
|||
Hydraulic Tank(L) |
270 |
|||
Crankshaft(L) |
20 |
|||
Transmission(L) |
52 |
|||
Front Axle(L) /Rear Axle(L) |
31/31 |
|||
Air Conditioning System |
|
|||
Heating Capacity(W) |
5800 (±10%) |
|||
Cooling Capacity(W) |
4500 (±10%) |
Our products will be continuously improved with the progressing of the technique without notice
- In the previous :CDM855 Wheel Loader
- The next article :CLG816G Wheel Loader